A lime kiln line pushes hot, dusty gas out of the preheater and cooler, and the cloth collector has to take that stream while keeping the stack clean. Our baghouse for lime kilns is rated for 10,000 to 50,000 m³/h of gas, with collection efficiency above 99% and a unit resistance kept under 1,500 Pa. The gas enters from around ambient up to 250 °C, so the media is chosen after the kiln temperature profile is known.
Inside, raw gas drops through the hopper where coarse lime dust settles by gravity, and the finer fraction stays on the outer face of the bags. Pulse air at 6–7 bar flexes the cages and knocks the cake off into the hopper. We fit a spark arrester ahead of the inlet, because hot clinker grit can reach the bags when the ductwork is short.
This matters in two ways for the operator. The outlet stays under the dust limit, and the differential holds flat, so the fan does not climb in power over the campaign. The cloth area is matched to the actual airflow, not a one-size estimate, and replacement bags follow the same tube-sheet drawing as the first set. Hopper ash drops through a rotary airlock valve before disposal.